Sedona V6-3.5L (2003)
5. Remove hub cap, cotter pin, cover set, nut and washer from the end of the spindle.
6. Remove brake drum from rear brake assembly.
7. Remove hub assembly after loosening bolts from hub assembly.
Notice: After disconnecting brake line, plug it to prevent fluid leakage.
8. Disconnect brake line with SST (OK130 430 019).
9. Disconnect lower brake pipes and flexible hoses from the middle of rear casting after loosening the brake pipe nuts and then pulling out the
flexible hose clips.
Notice: After disconnecting lower brake pipes and flexible hoses, plug them to prevent fluid leakage.
10. Loosen the bolts from rear casting and remove plate retainer, back plate, and spindle.
11. Loosen the shock absorber bolts and nuts and remove the shock absorber from the rear casting.
12. Loosen the lower arm bolt and two bolts from rear casting and remove lower arm bracket and lower arm.
13. Loosen the upper arm bolt from the rear casting and remove the upper arm.
14. Remove the stabilizer bracket and bolt in the middle of the rear casting.
