Sephia LS Sedan L4-1.8L (1998)
Driver Air Bag Module
1. Remove four air bag module retaining bolts from backside of steering wheel.
2. Pull air bag module away from steering wheel.
3. Disconnect air bag module connector from clockspring assembly and remove driver air bag module from vehicle.
4. If necessary, dispose of air bag module. Refer to Air Bag deployment and Disposal.
INSTALLATION
1. Ensure that front wheels are pointing straight ahead.
2. Holding surface of air bag away from you, couple blue air bag-SRS connectors, then couple the orange horn connectors.
NOTE: Orange and blue connectors are keyed to fit only one (1) way. When properly assembled, they will slip into place (using slight pressure)
with an audible "click". Do not force. If undue force is required, connectors are not aligned properly.
3. Set module into steering wheel, taking care not to pinch wiring harness.
4. Install four retaining bolts.
Tightening torque:
10-12 lb-ft (14-16 N.m, 1.4-1.6 kg-m)
