Sephia LS Sedan L4-1.8L (1998)
ACCIDENTAL DEPLOYMENT. NEVER CARRY MODULE BY ITS WIRING OR CONNECTORS.
D. ALWAYS PLACE LIVE AIR BAG MODULES FACE UP TO LESSEN MOTION OF MODULE IN CASE OF ACCIDENTAL
DEPLOYMENT. KEEP AREA CLEAR OF PARTS, TOOLS, AND DEBRIS.
E. NEVER PLACE ITEMS ON OR ABOVE TRIM COVER OF A LIVE AIR BAG MODULE. IN CASE OF ACCIDENTAL DEPLOYMENT,
SUCH ITEMS MAY CAUSE SERIOUS INJURY OR DEATH.
F. DAMAGED AIR BAG MODULES SHOULD BE STORED AWAY FROM ALL ACIDS, HALOGENS, HEAVY METALS, AND METAL
SALTS. DAMAGED UNITS MAY PRODUCE HYDROZOIC ACID IF EXPOSED TO LIQUIDS. IF AN UNDEPLOYED AIR BAG MODULE
OR INFLATOR IS RUPTURED OR TAMPERED WITH, REFER TO PARTICULAR MODULE'S MSDS (MATERIAL SAFETY DATA
SHEET) FOR IMPORTANT INFORMATION CONCERNING CONSTITUENTS OF UNDEPLOYED MODULES. EXPOSURE TO HIGH
CONCENTRATIONS OF PROPELLANT MIXTURE CAN CAUSE HEADACHES, NAUSEA, BLURRED VISION, FAINTNESS,
CYANOSIS, LOWERING OF BLOOD PRESSURE OR TACHYCARDIA. FAILURE TO COMPLY WITH THIS WARNING CAN RESULT
IN FIRE, NOXIOUS FUMES, SEVERE PERSONAL INJURY, OR DEATH.
G. AIR BAG MODULE COMPONENTS ARE VERY HOT AFTER DEPLOYMENT. UNITS SHOULD BE DEPLOYED OUTDOORS OR IN AN
OPEN AREA TO PREVENT FIRES. ALLOW COMPONENTS AT LEAST TWENTY MINUTES TO THOROUGHLY COOL. COOLING
MODULES SHOULD BE CONTINUOUSLY MONITORED TO ENSURE HOT COMPONENTS DO NOT CREATE FIRES WITH SPILLED
LIQUIDS OR OTHER DEBRIS. FAILURE TO ALLOW UNIT TO COOL COULD RESULT IN BURNS, FIRES OR PERSONAL INJURY.
H. ALWAYS WEAR RUBBER GLOVES AND SAFETY GLASSES WHEN HANDLING A DEPLOYED AIR BAG AND MODULE.
CAUTION: Storage, transportation, disposal and recycling of air bag module and components must be performed in accordance with all applicable
federal, state and local regulations including, but not limited to, those governing fire codes, environmental protection, occupational health and safety, and
transportation.
WARNING: FAILURE TO FOLLOW THE FOLLOWING PROCEDURES COULD RESULT IN PERSONAL INJURY OR DEATH.
1. Remove battery.
2. Wait 10 minutes before proceeding.
3. Disconnect appropriate Air Bag Module, and remove from vehicle.
4. Locate air bag in an area that will provide protection to personnel when it deploys. An example of a sate deployment site is a stack of used tires,
6-8 high, with undeployed bag located inside column of tires.
5. Connect air bag deployment tool (K95U-6000-BDY) to air bag module connector and position deployment tool 20 feet away from deployment
site.
6. Connect red lead to positive terminal of battery.
7. Connect black lead to negative battery terminal.
