Sephia LS Sedan L4-1.8L (1998)
11.
Position the engine compartment fuse/relay box to gain access to C192 on the bottom of the fuse/relay box.
* NOTICE
C192 is the black block-style connector located in the center of the fuse/relay box.
12.
Connect the 14 gauge blue wire from the relay to the bottom on the relay box male terminal spade lug.
13.
Locate connector terminal C192-61 (RED/WHT wire).
* NOTICE
C192-61 is the RED/WHI wire located on the right-hand side of the connector, five terminal holes from the top.
14.
Carefully cut C192-61 (RED/WHI wire) approximately 1 to 2 inches from C192.
15.
Strip approximately 1/4 inch of insulation off of the cut end of C192-61.
16.
Crimp (butt connect) the 22 gauge RED wire from the relay to the end of RED/WHI wire attached to C192-61.
17.
Remove the 12 mm bolt from G103 located under the fuse/relay box mounting bracket on the left hand engine compartment fender.
