Sephia LS Sedan L4-1.8L (1998)
Power Steering Fluid: Testing and Inspection
Fluid Pressure Check
INSPECTION OF FLUID PRESSURE
1. Assemble Special Service Tools (SST) (OK210 323 AAO or equivalent) as shown in the image, and tighten its fittings.
Tightening torque: 29 - 36 ft. lbs. (39 - 49 Nm)
2. Disconnect high-pressure hose from pump, and connect SST (OK210 323 AAO) between hose and pump.
NOTICE: Before disconnecting hose, place marks at connections for proper reinstallation.
3. Bleed air from system. (Refer to Power Steering Fluid Bleeding)
4. Open gauge valve fully. Start engine and turn steering wheel fully left and right to raise fluid temperature to 122 - 140°F (50 - 60°C).
NOTICE: If valve is left closed for more than 15 seconds, fluid temperature will increase excessively and damage oil pump.
5. Close gauge valve completely. Increase engine speed to 1,000 - 1,500 rpm and measure fluid pressure generated by power steering pump. If
