Sephia LS Sedan L4-1.8L (1998)
3. Slide boot along shaft to expose joint.
4. Mark tripod housing and shaft for proper reassembly.
5. Remove outer ring.
6. Mark shaft and tripod joint for proper reassembly.
7. Remove snap ring with snap ring pliers.
NOTICE: Do not damage needle bearings.
8. Drive tripod joint from shaft with a bar and a hammer.
9. Wrap splines of shaft with tape to prevent damaging boot.
10. Slide boot off shaft.
NOTICE: Do not remove dynamic damper unless necessary.
11. Pry up locking clip of damper retention band with a screwdriver.
12. Remove band with pliers.