Sephia Sedan L4-1.6L (1996)
1.
Completely lower the window and remove the door trim.
2.
Remove (and keep) the three (3) screws securing the outside mirror to the door.
3.
Remove the mirror from the door and disconnect the electrical connector (if equipped).
4.
Pull the door glass run down at the center, then continue to pull the door glass run out of the door window frame.
5.
Insert the top rear corner of the new door glass run into the window frame and push the rear edge into place.
NOTICE
Make sure the upper rear corner is fully seated in the door window frame.
6.
Push the bottom of the front vertical section of the door glass run down into the door.
