Sorento V6-3.5L (2004)
Fuse: Testing and Inspection
INSPECTION
1. Be sure there is no play in the fuse holders, and that the fuses are held securely.
2. Are the fuse capacities for each circuit correct?
3. Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the
problem before installing a new fuse.
CAUTION: Never use a fuse of higher capacity than specified.
INSPECTION OF FUSES
When a fuse is blown, there are two probable causes. The two causes can easily be determined by a visual check after removing the fuses.
1. Fuse blown due to over-current.
Prior to replacing the fuse with a new one, check the circuit for a short and the related parts for abnormal conditions. Only after the correction of a
short or replacement of abnormal parts, should a fuse with the same ampere rating be installed.
2. Fuse blown due to repeated on-off current.
Normally, this type of problem occurs after a fairly long period of use, and is less frequent than #1 above. In this case, you may simply replace
with a new fuse of the same capacity.
