Sorento V6-3.5L (2004)
1. Disconnect engine control module connector (or powertrain control module or engine/transaxle control module connector as indicated in the
following diagrams)
2. Measure resistance between identified terminal of Data Link/Check connector and chassis ground and between identified terminal of wiring harness
side of each control module and chassis ground.
3. If the measured resistance is below 1000 Ohms the harness is shorted to ground. Repair or replace the harness or additional connectors in the circuit
as necessary.
4. Apply dielectric grease before reconnecting.
Verification After Repair:
1. Turn ignition On.
2. Using Kia GDS Scan tool; clear DTC(s) and freeze frame data.
3. Start vehicle and let idle for 2 to 3 minutes.
4. Check the MIL and DTC/freeze frame data once again. Make sure MIL is not illuminated and that the P1330 DTC and associated freeze frame data