Sorento V6-3.5L (2004)
12.
Remove the brake booster vacuum hose clamp and disconnect the rubber hose from the steel line mounted on the bulkhead.
a)
Disconnect the fuel pressure regulator vacuum supply hose located next to brake booster hose on Intake Manifold Assembly.
13.
Remove the surge tank assembly from the vehicle.
14.
Using a clean work surface, remove the Intake Control Valve (ICV) from the Surge Tank.
15.
Clean the mating surfaces and install new sealing gaskets between the ICV and Surge Tank. These gaskets are included in the service kit.
Notice:
Follow torque procedure as outlined during assembly.
16.
Install ICV to the Surge Tank. Install the seven (7) Allen Head screws and torque to 84 inch lbs. (9.4 Nm).
17.
Transfer the vacuum valve to the new lower intake manifold, tighten the screws to 84 inch lbs. (9.4 Nm).
a)
Use new supplied C-clip and screws when transferring vacuum control Valve.
