Sorento V6-3.5L (2004)
5. Connect the deployment tool to the connector of each module.
6. As far away from the vehicle as possible, press the push button on the deployment tool to deploy the airbag.
CAUTION:
1. Before deploying the airbag in this manner, first check to be sure that there is no one in or near the vehicle. Wear safety glasses.
2. The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before attempting to handle
it. Although not poisonous, do not inhale gas from airbag deployment. See the Deployed Airbag Module Disposal Procedures for
post-deployment handling instructions.
3. If the airbag fails to deploy when the procedures above are followed, do not go near the module. Contact your DPSM.
DEPLOYED AIRBAG MODULE DISPOSAL PROCEDURES
After deployment, the airbag module should be disposed of in the same manner as any other scrap part, except that the following points should be
carefully noted during disposal.
1. The inflator will be quite hot immediately following deployment, so wait at least 30 minutes to allow it to cool before attempting to handle it.
2. Do not put water or oil on the airbag after deployment.
3. There may be adhered to the deployed airbag module, material that could irritate the eyes and/or skin, so wear gloves and safety glasses when
handling a deployed airbag module. If despite these precautions, the material does get into your eyes or on your skin, immediately rinse the
affected area with a large amount of clean water. If any irritation develops, seek medical attention.
4. Tightly seal the airbag module in a strong vinyl bag for disposal.
5. Be sure to always wash your hands after completing this operation.
