Sorento V6-3.5L (2004)
*NOTICE
Check the orientation of the Shift Fork to Shift Shaft before installing the case covers. Failure to do so may cause the 4WD low selection to be
inoperative.
27.
Apply the RTV to the case sealing surface area as shown using a 2.5 ~ 3.0 mm bead; do not use excessive sealant which can block the filter screen
causing lack of lubrication. Complete case half assembly.
a)
Install the torx bolt retaining the case halves, tighten to 19 ~ 25 ft. lbs. (25.7 ~ 33.8 Nm). Install the electrical harness bracket.
28.
The shift motor must be installed in several steps to prevent shift motor bind. Apply RTV to the sealing surface - shift motor to transfer case as
shown in Step 9a.
a)
Loosen the two nuts on the rear mounting bracket
b)
Install the three long bolts in the head area of shift motor, torque to 72 inch lbs. (8 ~ 11 Nm).
c)
Install the rear bolt on the mounting bracket, torque to 72 inch lbs. (8 ~ 11 Nm).
d)
Install and tighten the two nuts on the shift motor bracket, torque to 72 inch lbs. (8 ~ 11 Nm).
