Sorento V6-3.5L (2004)
29.
Install the remainder of components:
a)
Rear output flange
b)
Replacement O-ring seal
c)
Steel washer
d)
New replacement retaining nut.
e)
New replacement magnetic drain plug
f)
Fill the transfer case with 1.5 qts. of Transfer case oil (Shell Donax TG only) on the bench before installing transfer case into the vehicle.
g)
Install the damper weight if removed, torque to 25 ft. lbs. (33 Nm).
30.
Tighten the flange retaining nut to 150 ft. lbs. (203 Nm), using SST-K95B- 5009-D (Companion Flange Holder) to hold flange while torquing to
specification. Stake the nut to the shaft using a flat chisel.
31.
Replace the transfer case to transmission gasket and install transfer case into vehicle.
32.
Road test and check 4-wheel drive for proper operation and fluid leaks when complete.
