Sorento 2WD V6-3.3L (2008)
Brake Pedal Assy: Service and Repair
Repair Procedures
REMOVAL
1. Remove the stop lamp switch connector.
2. Remove the joint pin and snap pin.
3. Remove the nut and then remove the brake pedal.
INSTALLATION
1. Installation is the reverse of removal.
Nut tightening torque :
20-35 Nm (2.0-3.5 kg-m, 14-25 lb-ft)
CAUTION:
Coat the inner surface of the bushings with the specified grease.
Specified grease :
Chassis grease LiG-2
2. Before inserting the joint pin, apply the specified grease to the joint pin.
