Sorento 2WD V6-3.3L (2008)
3. Remove the brake hose from the caliper.
INSTALLATION (CALIPER)
1. Install the caliper mounting bolts.
Tightening torque :
65-75 Nm (6.5-7.5 kg-m, 47-54 lb-ft)
2. Refer to "Brake pad installation" for detail.
3. Install the brake hose connector
Tightening torque :
17-20 Nm (1.7-2.0 kg-m, 12-14 lb-ft)
4. Install the caliper guide bolt.
Tightening torque :
22-32 Nm (2.2-3.2 kg-m, 16-23 lb-ft)
5. Bleed the system.
CAUTION:
When replacing the piston seal, check the pedal stroke.If the pedal stroke is too excessive, the piston may not retain the piston seal.
Adjust as follows :
1. After removing the pad from the piston, push the piston into the cylinder 3-5mm. Put a lever or steel plate (1mm x 0.3m) between the piston and
disc, being careful not to damage the contact surface of the disc or the piston end.
2. Install the pad. To restore the brake pedal to the original position, step on it 2-3 times.
3. Repeat the above procedure more than 5 times and move the piston outward and inward to assure that the piston seal is properly installed.
4. Before driving a vehicle, step on the brake pedal and release it several times.
5. Perform the road test.