Sorento 2WD V6-3.3L (2008)
3. Install the piston boot to the piston.Confirm that the concave part of the piston is placed outward and the boot is seated in grooves of the piston
completely.
4. Install the piston and boot in the caliper housing. Insert the boot flange in the caliper housing and check that the boot fits in grooves around the
piston.
5. Apply the recommended oil to the inside of the locating pin insulator.
Inspection
INSPECTION (CALIPER)
1. Check the piston and its inside for wear, damage and rust.
Replace the damaged parts if necessary.
2. Check the piston seal, boot, and pin insulators for wear and damage.
Disassembly
DISASSEMBLY
Front disc brakes should be disassembled separately into the left and right as a set.
1. Remove the piston boot/piston.Blow compressed air into the brake hose seating hole so as to remove the piston and the piston boot.
NOTE:
When removing the piston, blow air slowly, adjusting the heights of the two pistons to push them out equally.
The secondary piston should not be removed before the primary piston is removed completely. Otherwise the secondary piston can't be removed.
