Sorento 2WD V6-3.3L (2008)
CAUTION:
1. All four pads must be replaced as a complete set.
2. When replacing the brake pads, check for deformation. When replacing the guide spring, use a new one or thoroughly clean the used one.
3. Press-fit the piston with a hammer handle or the special tool (09581-11000).
1. Lower and insert the brake cylinder carefully so as not to damage the boot.
2. Tighten the two guide rod bolts to the specified torque.
Tightening torque
Guide rod bolt :
22 - 32 Nm (220 - 320 kg-cm, 16 - 24 lb-ft)
INSTALLATION
1. Install the pads and brake cylinder.
2. Install the brake hose to the caliper.
Tightening torque
17-20 Nm (170-200 kg-cm, 12-14 lb-ft)
3. Fill the brake reservoir with brake fluid.
4. Bleed the system.
Rear Disc Brake
REMOVAL
1. Remove the wheel.
2. Remove the guide bolt, lift up the caliper assembly, and remove the pad assembly.
