Sorento 2WD V6-3.3L (2008)
CAUTION:
1. All four pads must be replaced as a complete set.
2. When replacing the brake pads, check for deformation. When replacing the guide spring, use a new one or thoroughly clean the used one.
3. Press-fit the piston with a hammer handle or the special tool (09581-11000).
1. Lower and insert the brake cylinder carefully so as not to damage the boot.
2. Tighten the two guide rod bolts to the specified torque.
Tightening torque
Guide rod bolt :
22 - 32 Nm (220 - 320 kg-cm, 16 - 24 lb-ft)
INSTALLATION
1. Install the pads and brake cylinder.
2. Install the brake hose to the caliper.
Tightening torque
17-20 Nm (170-200 kg-cm, 12-14 lb-ft)
3. Fill the brake reservoir with brake fluid.
4. Bleed the system.
Rear Disc Brake
REMOVAL (CALIPER)
1. Remove the rear wheel.
2. Remove the caliper assembly.
