Sorento 2WD V6-3.3L (2008)
11. Disconnect the injector connectors.
12. Disconnect the water hose on intake manifold from the nipple on the chain cover.
13. Remove the delivery pipe and intake manifold as an assembly.
NOTE:
Except such cases as defects of injectors or pipe, do not disassemble a delivery pipe from an intake manifold because it is one of the fuel system
parts, or you may have some problem in fuel system.
14. Install intake manifold and new gasket on the cylinder head.
Tightening torque
1st : 3.9 - 5.9Nm (0.4 - 0.6kgf.m, 2.9 - 4.3lb-ft)
2nd
Bolt : 26.5 - 31.4Nm (2.7 - 3.2kgf.m, 19.5 - 23.1lb-ft)
Nut : 18.6 - 23.5Nm (1.9 - 2.4kgf.m, 13.7 - 17.4lb-ft)
3rd : Repeat 2nd step twice or move.
NOTE:
Be careful of the installation direction.
a - h : 1st step order
1 - 8 : 2nd step order
15. Connect the water hose on intake manifold to the nipple on the chain cover.
16. Install delivery pipe. .
17. Install the surge tank and new gasket on the intake manifold.
Tightening torque
Long bolt : 9.80 - 11.76Nm (1.0 - 1.2kgf.m, 7.23 - 8.68lb-ft)
Short bolt, nut : 18.6 - 23.5Nm (1.9 - 2.4kgf.m, 13.7 - 17.4lb-ft)
18. Connect heater hose(A) and the brake vacuum hose(B).
19. Connect the fuel hose tube(A).
