Sorento 2WD V6-3.3L (2008)
8. Remove intake manifold.
INSTALLATION
1. Install intake manifold.
2. Install water pump pulley(A).
Tightening torque
7.84 - 9.80Nm(0.8 - 1.0kgf.m, 5.78 - 7.23lb-ft)
3. Install drive belt auto tensioner(A).
Tightening torque
81.4 - 85.3Nm(8.3 - 8.7kgf.m, 60.0 - 62.9lb-ft)
29.4 - 33.3Nm(3.0 - 3.4kgf.m, 21.7 - 24.6lb-ft)
4. Install drive belt idler(A).
Tightening torque
52.92 - 57.82Nm(5.4 - 5.9kgf.m, 39.06 - 42.67lb-ft)
5. Install alternator
6. Install air compressor
7. Install power steering pump.
8. Install drive belt(A).
Crankshaft pulley -> A/C pulley -> idler pulley -> alternator pulley -> water pump pulley -> P/S pump pulley -> tensioner pulley.
Rotate auto tensioner arm in the counter - clockwise moving auto tensioner pulley bolt with wrench.