Sorento 2WD V6-3.3L (2008)
diminishes at the same time oil pressure builds, there is no fault with the current design timing chain tensioners. No action or repair is necessary or
recommended.
NOTICE:
If necessary, this can be easily confirmed by installing an oil pressure gauge and monitoring the noise before and after oil pressure build-up.
Noise 2 - Valve Lash (Valve Tap) Type Noise - or - Excessive Timing Chain Noise
For valve tap type noise on one or more cylinders - or - for timing chain noise lasting longer then the initial 3 to 4 second start-up time, replace both LH
and RH timing chain tensioners with part number 24410 3C300, unless previously done.
NOTICE:
Engine removal is no longer recommended. Please see updated service information (on KGIS) and labor op time on timing chain tensioner
replacement.
Noise 3 - Catalyst Heat Shield Buzzing/Rattling Under Slight Load
NOTICE:
Check and adjust ALL heat shields on both front and rear catalysts. A good inspection measurement can be taken with a 3 mm hex wrench.
Effective Vehicle Information
Parts Information
Service Procedure