Sorento 2WD V6-3.3L (2008)
4. Remove the TP sensor from the ETC actuator.
Installation Procedure:
1. Lubricate the O-ring on the TP sensor and align the mating hole on
the throttle shaft while aligning the electrical terminals.
2. Install the new TP sensor to the ETC actuator and tighten the Torx T-20 screws hand tight only. Use Loctite(R) Threadlocker Green 290 on screws
during assembly.
3. Install the electrical connector to the TP sensor.
4. Install engine cover if removed.
5. Proceed to the reflash instructions.