Sorento 2WD V6-3.3L (2008)
Accelerator Pedal Position Sensor: Testing and Inspection
INSPECTION
FUNCTION AND OPERATION PRINCIPLE
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of
the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second
sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the
diagnostic system judges that it is abnormal.
SPECIFICATION
SCHEMATIC DIAGRAM
COMPONENT INSPECTION
1. Connect a scan tool to the Diagnosis Link Connector (DLC).
2. Start engine and check output voltages of APS 1 and 2 at C.T and W.O.T.
Specification: Refer to SPECIFICATION.