Sorento 2WD V6-3.3L (2008)
CAUTION:
-
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4. Connect the CAB connector.
5. Install the following parts.
A. Side trim, Roof trim
6. Reconnect the battery negative cable.
7. After installing the Curtain Airbag (CAB), confirm proper system operation:
A. Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Components and Components Location
COMPONENTS
Repair Procedures
REMOVAL
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the airbag module mounting bolts(2EA).
3. Disconnect the horn connector(A).
