Sorento 2WD V6-3.3L (2008)
5. Remove the power steering oil pump mounting bracket.
INSTALLATION
1. After installing the oil pump to the oil pump bracket.
Tightening torque:
18 - 23 Nm (1.8 - 2.3 kg-m, 13 - 16 lb-ft)
2. Install the belt and tighten the bolt adjusting tension to the specified torque.
3. Install the suction hose.
CAUTION:
Install the pressure hose to the oil pump.
4. Install the pressure hose to the oil pump.
NOTE:
Install the pressure hose being careful so that it does not twist and come in contact with other components.
5. Add power steering fluid (PSF-III).
6. Air bleed the system.
7. Check the oil pump pressure.