Sorento 2WD V6-3.3L (2008)
3. REMOVAL OF THE SIDE BEARING INNER RACES Fit the nut on top of the differential case, and then uses the special tool to remove the side
bearing inner race.
NOTE:
Attach the prongs of the special tool (09517-43001) to the inner race of the side bearing through the notched section in the differential case.
4. REMOVAL OF DRIVE GEAR
A. Make the match marks to the differential case and the drive gear.
B. Loosen the drive gear attaching bolts in diagonal sequence to remove the drive gear.
5. REMOVAL THE LOCK NUT
6. REMOVAL OF DRIVE PINION
A. Make the matchmarks on the drive pinion and companion flange.
CAUTION:
Match marks should not be made on the contact surfaces of the companion flange and the propeller shaft.
B. Drive out the drive pinion together with the drive pinion spacer and drive pinion front shims.
7. REMOVAL OF DRIVE PINION REAR BEARING INNER RACE
