Sorento 2WD V6-3.3L (2008)
3. Connect rear propeller shaft flange to companion flange on transfer. (4WD)
A. Align index marks on the flange and connect the flanges with four bolts and nuts.
B. Tighten the bolts.
Tightening torque :
50-60 Nm (5.0-6.0 kg-m, 36-43 lb-ft)
4. Connect the propeller shaft spline to transmission (2WD)
A. Align index mark on the spline and then install the propeller shaft.
B. Tighten the bolts holding the center bearing bracket.
Tightening torque :
37-54 Nm (3.7-5.4 kg-m, 27-39 lb-ft)
CAUTION:
-
Be careful not to damage the dust cover of propeller shaft when installing the propeller shaft (2WD)
5. Connect propeller shaft flange to companion flange on rear differential.
A. Align index marks on the flange and connect the flange with four bolts and nuts.
B. Tighten the bolts and nuts.
Tightening torque :
50-60 Nm (5.0-6.0 kg-m, 36-43 lb-ft)
6. After installing the propeller shaft fill the grease into the nipple until it comes out from the sleeve yoke plug hole.
