Sorento 2WD V6-3.3L (2008)
2. Remove the upper control arm link lock bolt, spring washer and nut.
3. Remove tie rod end cotter pin and using a ball joint puller, remove tie rod end from steering knuckle.
4. Mark drive shaft for identical installation position.
5. Using tool, pry the drive shaft from the differential housing.
NOTE:
-
Do not pull on the drive shaft doing so will damage the boots. Be sure to use the pry bar.
6. Remove the drive shaft from the knuckle
NOTE:
-
Temporarily install the knuckle to the upper arm.
INSTALLATION
1. Coincide the joining mark between the drive shaft and the differential and insert the shaft.
CAUTION:
-
Insert the drive shaft (RH side) carefully into the oil seal to avoid any damage.
2. Install the knuckle assembly and tighten.