Sorento 2WD V6-3.3L (2008)
2. Using a hydraulic press, install bearing onto output shaft.
3. Using a hydraulic press, install shaft with bearing into bearing housing.
4. Install the output shaft housing to the bearing housing.
Tightening torque :
71-95 Nm (7.1-9.5 kg-m, 51-68 lb-ft)
5. Using a plier, install new clip onto output shaft.
Disassembly
DISASSEMBLY
NOTE:
-
Do not disassemble the B.J assembly.
-
The Drive shaft joint uses special grease. Do not substitute with another type of grease.
-
The Boot band should be replaced with a new one.
1. Remove the T.S.J boot band and pull the boot from T.S.J outer race.
NOTE:
Be careful not to damage it.