Sorento 2WD V6-3.3L (2008)
2. Remove the clip using a screwdriver.
3. Remove the drive shaft from the T.S.J outer race.
4. Remove the snap ring and disassemble the inner race and ball from the shaft.
5. Remove the B.J boot band and pull out the T.S.J boot and the B.J boot.
CAUTION:
If the boot is reused, wrap a tape around the drive shaft splines to protect the boot.
Reassembly
REASSEMBLY
1. Wrap a tape around the drive shaft spline (T.S.J side) to avoid boot damage.
2. Apply specified grease to the drive shaft and install the boots.
3. Add specified grease as much as was wiped away at the time of inspection.
4. Tighten the boot bands.
CAUTION:
Keep the specified distance between the boot bands to control the air when they are tightened.