Sorento 2WD V6-3.8L (2007)
8. Disconnect the surge tank stay.
9. Remove the surge tank.
10. Loosen the cylinder head cover bolts and then remove the cover(A) and gasket.
11. Set No.1 cylinder to TDC/compression.
a. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain cover.
b. Check that the mark(A) of the camshaft timing sprockets are in straight line on the cylinder head surface as shown in the illustration.
If not, turn the crankshaft one revolution (360°)
NOTE
Do not rotate engine counterclockwise
12. Inspect the valve clearance.
a. Check only the valve indicated as shown. [No. 1 cylinder : TDC/Compression] measure the valve clearance.
