Sorento 2WD V6-3.8L (2007)
SENSOR FIT
CAUTION:
^
Handle the sensor with care.
^
Avoid lubricant contact if possible.
1. Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
CAUTION:
^
The fit should not be tight i.e. it should still be possible to easily adjust valve angle.
^
Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.
^
Ensure that the valve hole and mating face of the wheel are clean.
2. Mount assembly to wheel.
CAUTION: Ensure sensor feet are against the wheel throughout the remainder of the assembly process.
3. Tighten washer and nut by hand until the valve thread meets the nut built-in calibrated stop.
CAUTION: Ensure that the grommet remains in contact with the wheel
4. Using a torque wrench, tighten the nut to 2.95 ± 0.37 lb-ft (4.0 ± 0.5 Nm) It is normal to feel a break as the 1.7 lb-ft (2.3 Nm) calibrated stop in
the nut snaps and the torque falls.
