Sorento 2WD V6-3.8L (2007)
3.
Connect the Main 16-pin DLC cable (GHDM - 241000) to the VCI.
4.
Connect the Main 16-pin DLC cable (GHDM - 241000) to the OBD-II connector, located under the driver's side of the instrument panel.
5.
With the ignition key ON, turn On the VCI and GDS tool. Access the vehicle identification number (VIN) screen and configure the vehicle using
the VIN AUTO DETECT function.
6.
At the Main Screen, select ECU UPGRADE from the menu buttons located on the bottom of the screen Next, "Auto Mode", engine.
7.
Perform the PCM upgrade in accordance with normal tool upgrade procedures.
NOTE:
Global Diagnostic System (GDS) users should access the "NOTICE" function from the GDS Main Screen for instructions reguarding ECU
upgrade events.
NOTICE:
DO NOT attempt to perform a Manual Mode PCM upgrade unless Auto Mode fails. Always follow the instructions given on the GDS tool in
either Auto or Manual mode. See table above for Manual Mode passwords.
8.
When the GDS tool reports that the PCM upgrade has been successfully completed, click OK, turn OFF the ignition key, and wait at least 20
seconds before attempting to start the engine.
9.
Check for Diagnostic Trouble Codes using the and erase any DTCs stored in the Engine and Transaxle control modules.
10.
Confirm proper shift points of A/T units after reprogramming to reduce customer complaints of excessive shift shock and improper shift points.
