Sorento 2WD V6-3.8L (2007)
Starter Motor: Service and Repair
STARTER
REMOVAL
1. Remove the LH exhaust manifold assembly.
2. Supporting the engine with a safety jack, remove the LH side engine mounting bracket(A).
3. Disconnect the starter cable from the B terminal on the solenoid, and the connector from the S terminal.
4. Remove the 2 bolts (D) holding the starter, then remove the starter (E).
TORQUE: 49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 lb.ft) - starter mounting (D)
5. Installation is the reverse of removal.
6. Connect the battery negative cable to the battery.
DISASSEMBLY
1. Disconnect the M-terminal on the magnet switch assembly.
2. After loosening the 3 screws (A), detach the magnet switch assembly (B).