Sorento 2WD V6-3.8L (2007)
1. Compress and expand the shock absorber three to four times and analyze for uniform working force and abnormal noise.
2. Inspect for gas leakage.
3. Inspect the shock absorber for a worn or deteriorated rubber bushing.
4. Replace the rear shock absorber assembly if a problem is found.
5. Inspect the rear coil spring for bends, cracks or other damage.
6. Inspect the upper rubber seats for tears and/or deterioration.
7. Inspect the rear jounce stop for damage and/or deterioration.
8. Replace if damaged, deformed or cracked; replace bushings if worn or deteriorated.
INSTALLATION
1. Position the upper rubber seat to the coil spring.
CAUTION: Align the spring end with the groove of the spring pad and fix the spring and the spring pad by adhering the 3 parts with tape.
2. Slowly raise the rear axle housing while installing the coil spring.
3. Install the shock absorber upper nut.
Tightening torque: 122 - 140 Nm (12.2 - 14 kg-m, 88 - 101 ft. lbs.).
