Sorento 2WD V6-38L (2007) Tire Pressure Sensor Service and Repair Procedure
CAUTION:
^
Increase torque smoothly in order to achieve a clean break of the stop.
^
Do not exceed allowed torque.
^
Do not use electric or pneumatic tools.
TIRE FIT
CAUTION: Only use wheels designed to accommodate the TPMS sensor.
1. Lubricate the tire bead not the rim. Excessive lubrication should not be applied.
2. Start tire mounting approx. 5.9 in (15 cm) from valve.
3. Move the mounting tool away from the valve.
CAUTION: Avoid tire / tool contact with the valve.
4. Finish with mounting tool near to valve.
5. Carry out inflation / pressure correction and then fit valve cap.
SENSOR INITIATING PROCEDURE
1. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).
NOTE:
^
It is possible to avoid registering each sensor by reading back the learned sensor list and only registering the new sensor in the missing sensor
position (if there is a missing position).
^
The handheld test tool will automatically check to see whether the receiver is High or Low Line.
^
It will then automatically configure sensors accordingly and write their ID' s to the receiver memory.
^
Note that sensors which were already configured as Base (Low Line) will take longer to read.
