Sorento 2WD V6-3.8L (2007)
1. Connect propeller shaft flange to companion flange on front differential (4WD).
a. Align index marks on the flange and connect the flanges with four bolts and nuts.
b. Tighten the bolts and nuts.
Tightening torque: 26 - 30 Nm (2.6 - 3.0 kg-m, 19 - 21 ft. lbs.)
^
Full time 4WD 50 - 60 Nm (5.0 - 6.0 kg-m, 36 - 43 ft. lbs.)
^
Part time 4WD
2. Connect front propeller shaft flange to companion flange on transfer (4WD).
a. Align index marks on the flange and connect the flanges with four bolts and nuts.
b. Tighten the bolts.
Tightening torque: 50 - 60 Nm (5.0 - 6.0 kg-m, 36 - 43 ft. lbs.)
3. Connect rear propeller shaft flange to companion flange on transfer.(4WD)
a. Align index marks on the flange and connect the flanges with four bolts and nuts.
b. Tighten the bolts.
Tightening torque: 50 - 60 Nm (5.0 - 6.0 kg-m, 36 - 43 ft. lbs.)
4. Connect the propeller shaft spline to transmission (2WD)
a. Align index mark on the spline and then install the propeller shaft.
b. Tighten the bolts holding the center bearing bracket.
Tightening torque: 37 - 54 Nm (3.7 - 5.4 kg-m, 27 - 39 ft. lbs.)
CAUTION:
