Sorento 4WD V6-3.3L (2008)
Thermostat: Service and Repair
Repair Procedures
REMOVAL
THERMOSTAT
NOTE:
Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine
tends to overheat.
1. Drain engine coolant so its level is below thermostat.
2. Remove water inlet(A) and thermostat(B).
INSTALLATION
THERMOSTAT
1. Place thermostat in thermostat housing.
(1) Install the thermostat with the jiggle valve upward.
(2) Install a new thermostat(B).
2. Install water inlet(A).
Tightening torque
16.66 - 19.60Nm (1.7 - 2.0kgf.m, 12.30 - 14.47lb-ft)
3. Fill with engine coolant.
4. Start engine and check for leaks.
