Sorento 4WD V6-3.3L (2008)
(1) Disconnect the injection harness connector(A).
(2) Disconnect the camshaft position sensor(CMP) harness connector(B).
(3) Disconnect the ground lines(C).
(4) Disconnect the ignition coil harness connector(D).
(5) Disconnect the condenser connector(E).
(6) Disconnect the oil control valve(OCV) harness connector(F).
6. Loosen the cylinder head cover bolts and then remove the cover(A) and gasket.
7. Set No.1 cylinder to TDC/compression.
A. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain cover.
NOTE:
Do not rotate engine counterclockwise.
B. Check that the mark(A) of the camshaft timing sprockets are in straight line on the cylinder head surface as shown in the illustration.
If not, turn the crankshaft one revolution (360°).
NOTE:
Do not rotate engine counterclockwise.
8. Remove the lower oil pan(A).
Insert the blade of SST(09215-3C000) between the upper oil pan and lower oil pan, and cut off applied sealer and removed lower oil pan.
