Sorento 4WD V6-3.3L (2008)
10.
Ensure that during the installation of the field coil and ground bolt, the field coil is seated completely around the circumference of the compressor
housing.
11.
Install the new pulley assembly and the pulley retainer snap ring.
NOTICE:
during installation of retainer snap ring on DOOWON manufactured Compressors, there is a specific orientation of the snap ring to the pulley
assembly. Insure that the beveled/sloped side of the snap ring is installed in the "UP" position.
12.
Reinstall the spacer shim and disc & hub to the compressor using a new bolt. If new bolt is not available, re-use old bolt after applying Loctite #
242 and tighten:
HALLA compressor: torque to 7.2-10.8 lbs-ft
DOOWON compressor: torque to 11-15. lbs-ft
13.
Reinstall the A/C compressor and recharge the refrigerant as outlined in the service manual.
14.
Verify proper operation of HVAC system.
