Sorento 4WD V6-3.3L (2008)
4.
Remove the disc + hub assembly by sliding it off the compressor shaft. No Special Tool or puller is required.
!WARNING
An adjustment shim that is responsible for disc + hub to drive pulley clearance may stick to the end of the compressors shaft, stay inside the original
hub assembly, or fall to the floor!
5.
Transfer the original disc + hub clearance adjustment shim to the new redesigned disc + hub assembly.
6.
Reinstall the new redesigned disc + hub assembly. Lightly tighten the assembly bolt using hand tools and SST 09977-29000. Finish tightening
using a torque wrench set to 7.2 ~ 10.8 lb-ft (86.4 to 129.6 lb-in). Remove clutch hub tool.
!WARNING
Do NOT use power tools when installing the disc + hub assembly bolt! Bolt is easily broken off if not properly tightened to specification.
7.
Start the engine with the A/C off. Check that the newly installed disc + hub assembly does not rub or drag on the compressor pulley. If drag
occurs, the shim was not transferred properly.
8.
Turn ON the A/C and check that the disc + hub assembly engages the compressor pulley without slipping. If slipping occurs, inspect the shim
location and proper clutch hub installation.
9.
Close Hood, repair is complete.
