Sorento 4WD V6-3.3L (2008)
Body Control Module: Service and Repair
REMOVAL
1. Disconnect the negative (-) battery terminal.
2. Remove the side panel (A).
3. Remove the heater control unit (A) after loosening the 4 screws.
4. Remove the center panel (A) after loosening the 6 screws.
5. Remove the BCM (A) after loosening the 2 nuts and disconnecting the connector.
INSTALLATION
1. Connect the connector and reassemble the BCM.
2. Reassemble the center panel, heater control unit and side panel.
