Sorento 4WD V6-3.3L (2008)
Impact Sensor: Service and Repair
Side Impact Sensor (SIS)
Components and Components Location
COMPONENTS
Repair Procedures
REMOVAL
CAUTION:
-
Removal of the airbag must be performed according to the precautions/procedures described previously.
-
Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).
-
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. Remove the lower anchor bolt.
3. Remove the following parts.
A. Door scuff trim, Center pillar trim
4. Disconnect the Side Impact Sensor connector and remove the Side Impact Sensor mounting bolt.
INSTALLATION
CAUTION: