Sorento 4WD V6-3.3L (2008)
4. Connect the seat OCS connector to the OC reflash tool and connect to the rear power outlet.
5. You are now ready to reflash the seat control module. Push the reflash start button on the tool to initiate the communication and reflash the internal
logic with the tool.
Notice
ONLY vehicles within the affected production date should be reflashed.
6. The green and red LED lights will toggle back and forth approximately 60 times during the reprogramming.
^ After a successful reprogram, the GREEN LED will flash 3 quick blinks, folloowed by a steady green light.
^ If the RED LED flashes 3 quick blinks followed by a steady red light, the reprogram was unsuccessful.
Possible cause for this event:
- Check the cable connections to the power supply and OCS seat connector.
- Verify the proper production date on the vehicle.
