Sorento 4WD V6-3.3L (2008)
Tire Pressure Sensor: Procedures
Sensor Initiating Procedure
1. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).
NOTE:
^
It is possible to avoid registering each sensor by reading back the learned sensor list and only registering the new sensor in the missing sensor
position (if there is a missing position).
^
The handheld test tool will automatically check to see whether the receiver is High or Low Line.
^
It will then automatically configure sensors accordingly and write their ID to the receiver memory.
^. Note that sensors which were already configured as Base (Low Line) will take longer to read.
