Sorento 4WD V6-3.3L (2008)
Tire Pressure Sensor: Testing and Inspection
Sensor Initiating Procedure
1. Read the four sensor's ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).
NOTE:
-
It is possible to avoid registering each sensor by reading back the learned sensor list and only registering the new sensor in the missing sensor
position (if there is a missing position).
-
The handheld test tool will automatically check to see whether the receiver is High or Low Line.
-
It will then automatically configure sensors accordingly and write their ID's to the receiver memory.
-
Note that sensors which were already configured as Base (Low Line) will take longer to read.
2. Connect 'TPMS exciter' to the diagnostic connector.
3. Register the four sensor's ids to the receiver.
