Sorento 4WD V6-3.3L (2008)
During reassembly make sure parking brake cable is properly adjusted to ensure proper brake operation.
3. Drain rear differential oil and proceed to Step 4 while differential oil is draining.
4. Remove the parking brake bracket bolt as shown in the first photo. Then remove the second parking brake bracket located on top of the rear of the
differential carrier housing as shown in the second photo. This will provide enough slack in the parking brake cable to allow axle shafts to be partially
slid outward.
5. Propeller shaft assembly removal: Remove the four (4) bolts and nuts; then remove propeller shaft assembly.
NOTICE
Mark propeller shaft and companion flange with a paint marker (indicated by arrow) before removing propeller shaft to ensure proper indexing when
reinstalling propeller shaft.