Sorento 4WD V6-3.5L (2011)
^ When the PCM upgrade is completed, turn the ignition "OFF" and wait 20 seconds before starting the engine.
^ ONLY use approved PCM upgrade software designated for the correct model, year.
ROM ID INFORMATION TABLES
To verify the vehicle is affected, be sure to check the Calibration Identification of the vehicle's PCM ROM ID and reference the Information Table as
necessary.
1. Connect the power supply cable to the GDS tool.
NOTICE
If attempting to perform the PCM upgrade with the power supply cable disconnected from the GDS tool, be sure to check that the GDS tool is fully
charged before PCM upgrade. If the GDS tool is not fully charged, failure to perform the PCM upgrade may occur. Therefore, it is strongly
recommended that the power supply connector be connected to the GDS tool.
2. Connect the USB cable between the VCI and the GDS tool.
NOTICE
When performing the PCM upgrade using the GDS tool, wireless communication between the VCI and the GDS tool is not available. Therefore, be sure
to connect the USB cable between the VCI and the GDS tool.
3. Connect the Main 16-pin DLC cable (GHDM - 241000) to the VCI.
4. Connect the Main 16-pin DLC cable (GHDM - 241000) to the OBD-II connector, located under the driver's side of the instrument panel.
