Sorento 4WD V6-3.5L (2011)
Engine Control Module: All Technical Service Bulletins
Campaign SA075 - ECM Update For MIL ON/DTC P0017
GROUP Engine
NUMBER 094
MODEL 2011MY Sorento (XM) w/3.5L
DATE January 2011
SUBJECT:
COMBINED TSB / SERVICE ACTION: MIL ON WITH DTC P0017 DTC LOGIC IMPROVEMENT (SA075)
This bulletin provides the procedure to upgrade the Powertrain Control Module (PCM) of some 2011 Model Year Sorento (XM) vehicles equipped with
3.5L engine prior to December 7, 2010. Some vehicles may experience a Malfunction Indicator Lamp (MIL) illuminated with system-related DTC
P0017 stored in the PCM. For confirmation that the latest reflash has been performed to a vehicle you are working on, verify ROM ID using the tables in
this TSB.
^ P0017: Crankshaft Position - Camshaft Position Correlation (Bank 1, Sensor B)
To correct this condition, the PCM should be reprogrammed using the GDS download as described in this bulletin.
*NOTICE
A Service Action is a repair program without customer notification that is performed during the warranty period. Any dealer request to perform this
repair outside the warranty period will require DPSM approval.
Repair status for a VIN is provided on WebDCS (Service > Warranty Coverage > Warranty Coverage Inquiry > Campaign Information). Not Completed
Recall/Service Recall reports are available on WebDCS (Consumer Affairs > Not Completed Recall Recall VIN > Select Report).
The issue number is SA075.
*NOTICE
^ A fully charged battery is necessary before ECM upgrade can take place. It is recommended that the Midtronics GR8 1299 system be used in ECM
mode during charging. DO NOT connect any other battery charger to the vehicle during ECM upgrade.
^ All ECM upgrades must be done with the ignition key in the "ON" position with the blower motor in the "OFF" position during ECM upgrade.
^ Be careful not to disconnect any cables connected to the vehicle or GDS during the PCM upgrade procedure.
^ DO NOT start the engine during ECM upgrade.
^ DO NOT turn the ignition key "OFF" or interrupt the power supply during ECM upgrade.
^ When the ECM upgrade is completed, turn the ignition "OFF" and wait at least 10 seconds before starting the engine, according to instructions
displayed on the GDS tool.
