Sorento 4WD V6-3.8L (2009)
18. Pull out the pins of hydraulic tensioner (LH & RH).
19. Install oil pump chain cover(A).
Tightening torque
9.80 - 11.76Nm(1.0 - 1.2kgf.m, 7.23 - 8.68lb-ft)
20. After rotating crankshaft 2 revolutions in regular direction(clockwise viewed from front), confirm the timing mark.
NOTE:
Always turn the crankshaft clockwise.
21. Install timing chain cover.
A. The sealant locations on chain cover and on counter parts (cylinder head, cylinder block, and lower oil pan) must be free of engine oil and
ETC.
B. Before assembling the timing chain cover, the liquid sealant TB1217H should be applied on the gap between cylinder head and cylinder block
The part must be assembled within 5 minutes after sealant was applied.
Bead width : 2.5mm(0.1in.)
C. After applying liquid sealant TB1217H on timing chain cover.
The part must be assembled within 5 minutes after sealant was applied.
Sealant should be applied without discontinuity.
Sealant should also be applied all around the two holes of the dowel pins.
Bead width : 2.5mm(0.1in.)